Hayward W3GLX-CELL-5 AquaTrol® TurboCell 20K gal with 15' Cord automatically converts pool salt into chlorine while providing above ground pools with consistent sanitization. Experience the luxurious, silky soft water that won't irritate eyes, dry out skin or cause fabrics to fade.
Hayward W3GLX-CELL-5 AquaTrol® TurboCell 20K gal with 15' Cord automatically converts pool salt into chlorine while providing above ground pools with consistent sanitization. Experience the luxurious, silky soft water that won't irritate eyes, dry out skin or cause fabrics to fade.
Features
- This cell IS compatible with older AquaTrol Salt Systems.
- Allows for maximum chlorine generation efficiency and minimal flow restriction
- Installs in minutes via a simple plug
- This is a direct replacement for the T-CELL-5 for pools up to 20,000 Gallons
- Superior value and longer life than low-cost generic cells
- 3-Year warranty
- Specifications
| Brand | Hayward |
| Capacity | 20000 gal |
| Carton Weight | 4 lbs |
| For Use With | Goldline AquaTrol Salt Chlorination Systems |
| Includes | 15 ft Cable |
| Item Name | Hayward Replacement Turbo Cell |
| Type | Replacement Part |
The GLX-CELL-5 and GLX-CELL-5-W are designed for pools up to 20,000 gallons. When replacing an existing T-CELL-5 or
GLX-CELL-5, no re-configuration is neccessary.
Configuration of your controller may be required before using the GLX-CELL-5 or GLX-CELL-5-W chlorinator cell. Refer to the
information below. Incorrect configuration will cause inaccurate salt readings, improper operation, and possible system shutdown.
CONFIGURATION is necessary with the following models:
• AQR (Aqua Rite - all 2009 or later) - firmware version 1.5 or later
• AQR-PRO (Aqua Rite Pro)
• PL-P-4 (Pro Logic P4)
• PL-PS-x (Pro Logic PS)
• AQ-LOGIC-P-4 (Pro Logic P4)
• AQ-LOGIC-PS-x (Pro Logic PS)
NO CONFIGURATION is neccessary with the following models:
• AQ-TROL
Connecting to an AQR:
1. Slide the Main Switch to the “Auto” position.
2. Push the Diagnostic button repeatedly until “t-xx” appears on the display (“t-15” is the factory default).
3. To change cell type, slide the Main Switch from “Auto” to “Super Chlorinate” and back to “Auto”. Repeat this process until
the “t-5” is displayed.
4. Push the Diagnostic button to exit.
Connecting to an AQR-PRO:
1. Access the Settings Menu by pushing the “Settings” button.
2. Push “>” until Chlor. Config is displayed, then push “+”.
3. Push “>” repeatedly until “Cell Type” is displayed.
4. Push “+” or “-” until “T-CELL-5” is displayed.
5. Exit Settings Menu by pushing the “Info” button.
Connecting to an AQ-LOGIC-P-4, AQ-LOGIC-PS-x, PL-P-4 or PL-PS-x:
1. Enter the Configuration Menu.
2. Push “>” until Chlor. Config is displayed, then push “+”.
3. With the Chlorinator Enabled, push “>” repeatedly until “Cell Type” is displayed.
4. Push “+” or “-” until “T-CELL-5” is displayed.
5. Exit Settings Menu by pushing the “Menu” button.
