Raypak Digital Natural Gas 336,000 BTU Pool Heater, 009218
- LCD digital display provides accurate temperature
- Monitors operational status as well as service diagnostics
- High-wind resistance
- Corrosion-resistant headers
- Unitherm governor prevents condensation
- PVC plumbing directly to the heater
- Small footprint
- Can be installed on combustible surface
Microprocessor-Controlled Thermostat control allows you to set your pool and spa temperature precisely at your preferred setting just by pressing an up or down temperature control button. The digital display tells you when the water is being heated and notifies you when your target temperature has been reached.
Self-Diagnostics let the user and the service professional know what is going on with the heater at all times. The display uses real English, with no cryptic codes to decipher.
Remote-Compatible so any two- or three-wire remote can connect to the Raypak Digital and be integrated into the pool control system of your choice. The display clearly shows the heater is under control of a remote system.
Run Time and Cycle Meter reports how long it has run and how many times it has fired. This is valuable feedback for the service professional. Multi-unit installations can monitor the run time of each unit and balance out the duty load, thus avoiding over working one individual heater.
Flame Strength Indicator to monitor and measure the pilot flame signal. This little tool is a service tech's dream. Raypak also uses this function on the end of line test, making sure every heater leaves with a robust flame signal.
On Board Voltmeter helps ensure the heater is wired properly during installation. The heater will also let you know if the voltage has dropped too low to function properly.
Condensation-Free Operation regulates low-temperature incoming water to help reduce condensation. The built-in automatic bypass helps prevent scaling and erosion by balancing the flow going into the heat exchanger.
Rust-Free Waterways make sure your heater will last.
Stainless Steel Burners are self-adjusting to compensate for gas pressure fluctuations, allowing the heater to always burn clean and safe.
Copper Fin Tube is built to last with the highest quality integral copper fin tube available. Copper is well known for its ability to efficiently transfer heat, and is the first choice for pool and spa heat exchanger construction. Pure copper has stood the test of time as the industry standard for efficiency, quality and product life.
- Elevation: 0' to 2,000'
- Shipping Weight: 230 Lbs
- Gas: Natural Gas
- Model Number: P-R336A-EN-C #50
- Part Number: 009218
- BTU: 336,000
- 2" Intake and discharge water connections